My Garage Add a vehicle

Pick your vehicle in the Shop By Vehicle bar below and every page shows the parts that fit it.

Cart
Reset

Leed Brakes Manual Hydraulic Kit with pre-bent lines and adjustable valve for Ford Bronco

Part # FC5001HKSKU LEEFC5001HK

Set your vehicle above for a fit verdict. 2 vehicles listed below.

Specifications
BrandLeed Brakes
Part typeBrake Master Cylinder
Bleeder Hoses IncludedYes
Bleeder Screw IncludedNo
Bore TypeStraight
Brake Booster IncludedNo
Brake Pressure Switch RequiredNo
Dust Boot IncludedNo
Gasket Or Seal IncludedYes
Grade TypeStandard Replacement
Master Cylinder Bore Diameter1.00 in
Master Cylinder Bore Size1 in
Master Cylinder Cap IncludedYes
Master Cylinder FinishNatural
Master Cylinder IncludedYes
Master Cylinder MaterialCast Iron
Mounting Bracket IncludedNo
Mounting Hardware IncludedNo
Mounting Hole Diameter.400 in
Mounting Hole Quantity2
Piston Quantity2
Port Quantity2
Primary Bore Diameter1.00 in
Primary Outlet Flare TypeInverted
Primary Outlet Thread Size1/2" - 20
Primary Outlet Thread Type StandardUNF
Push Rod IncludedNo
Reservoir IncludedYes
Reservoir MaterialCast Iron
Reservoir StyleIntegral
Reservoir TypeDual
UPC / GTIN00887753640666
WarrantyLimited Warranty, See PDF
  • All new high quality components

Description

Upgrade your truck to a 1 in. dual bore master cylinder with our quick install kit. In this kit you receive the brake line necessary to route from the new master cylinder to your factory distribution block. Additionally we include an adjustable combo. This adjustable valve allows you to fine tune the amount of pressure your rear brakes receive in order to prevent rear wheel lockup. A great kit with a factory look and easy installation!

Fits these vehicles 2

YearMakeModelSubmodel
1966 - 1974FordBroncoBase
1975FordBroncoCustom